AMSOIL PowerSports Air Filters for dirtbikes
and ATVs extend equipment life, increase power and save money.
PowerSports Air Filters feature two layers of oil-wetted polyurethane
foam that provide a superior job at stopping dirt while maximizing
air flow. Their special design improves performance, allows for
better fuel economy and reduces wear.
AMSOIL PowerSports Air Filters save money.
They are washable and reusable for hours of trouble-free service.
In addition, PowerSports Air Filters have greater life expectancy
than competitive air filters.
PRODUCT DESCRIPTION
AMSOIL PowerSports 2-Stage Air Filters provide
superior performance in all three critical areas of filtration:
Efficiency (dirt-stopping), Capacity
(dirt-holding) and Resistance
(air flow).
AMSOIL PowerSports 2-Stage Air Filters are uniquely
designed to hold wear-causing dirt while allowing only clean air
for better performance, better fuel economy, lower exhaust emissions
and longer engine life. Also, AMSOIL PowerSports 2-Stage Air Filters
are washable and reusable for numerous hours of trouble-free service.
AMSOIL PowerSports 2-Stage Air Filters are especially
designed for PowerSports such as ATV's and Dirt Bikes. The filters
feature two distinct layers of oil-wetted polyurethane foam, which
provides a network of interlocking cells that trap particles primarily
on the surface, yet allow a constant flow of clean intake air
for outstanding engine protection and performance.
AMSOIL PowerSports 2-Stage Air Filters are constructed
of polyurethane foam and the 2-stage foam's thickness allows for
even more filtering area and capacity to trap dirt over a longer
period of time.
POWERSPORTS FILTER CLEANING AND OILING PROCEDURES
The AMSOIL PowerSports 2 Stage Air Filter is
constructed with the highest quality foam filter media available.
This filter, when used in combination with AMSOIL Foam Filter
Oil (AFO), will maximize engine performance and provide the most
effective filtration available for your engine.
NOTE: OIL BEFORE USE! AMSOIL PowerSports 2 Stage
Air Filters are packaged dry. Proper filter oiling before use
is necessary to prevent dirt from entering the air intake system.
AMSOIL recommends using AMSOIL Foam Filter Oil (AFO). AFO is properly designed with high quality
tacking agents that stick to dirt. AMSOIL Foam Filter Oil (AFO)
is available in 8 oz. containers and can be purchased through
your AMSOIL Dealer.
Follow the instructions below to properly prepare
your filter for use.
Your local conditions and intended use will determine
how often your air filter should be inspected and cleaned. Frequent
cleaning and oiling is necessary for best performance and protection
against engine wear.
Filter cleaning:
1) Carefully remove the air filter being cautious
not to knock any dust or dirt into the carburetor opening. Clean
any dirt from the opening with a clean shop towel.
2) Clean filter in a solution of warm water
and mild detergent. Do not use strong solvents, gasoline, or
other fuels to clean the filter.
3) After washing, thoroughly rinse the filter
with clean water and allow it to air dry. Note:
Do not use high-pressure shop air or heat to dry the filter.
After the filter is completely dry it can be re-oiled for further
use.
Applying filter oil:
For best performance, use a generous amount
of filter oil and work it into foam media. Squeeze out excess
oil, leaving a uniformly oiled filter.
A properly oiled filter will feel oily or tacky
to the touch on both the outer and inner surfaces, but should
not be dripping filter oil.
When reinstalling the filter use a thin film
of Multi-Purpose Grease on the foam base to insure a leak free
seal between the filter and the housing.
